With high efficient control system and accurate landing system, AOYAMA cargo elevator can make goods transportation so easy. AOYAMA is always in the spirit of quality first, user-friendly, energy-saving and environmentally-friendly, benefiting the society to achieve excellence. The load range is from 1T to 7T. The energy-saving control system can efficiently save the energy even with super large load.
Center Open/Side Open
Collective selective control
Collective selective controlling without the presence of operator.
Reopen with hall call
In the door closing process, press reopen with hall call Button can restart the door.
Car stops and door open
The elevator decelerates and levels, the door only opens after the elevator comes to complete stop.
Automatic returning to the base station
When the traffic flow is low, elevator without receiving commanding signals will automatically return to the base floor and standby with the door closed.
Under the operator’s control, after the direct running button is pressed, the elevator only runs directly according to the directives from inside the car and does not respond to any calls from outside.
Automatic pass without stop
When the car is crowded with the passengers or the load is closed to preset value, the car will automatically pass the calling landing in order to keep maximum travel efficiency.
Repeated door closing
If the elevator can not close the door due to certain obstacle or interference, the elevator will reopen or reclose the door until sundries are eliminated.
Power on re-leveling
A power failure might cause the elevator to stop between two floors. However, upon recovery of the power, the car automatically moves to the nearest leveling floor.
Overload holding stop
When the car is overload, the buzzer rings and stops the elevator in the same floor.
Anti-stall timer protection
The elevator stops operation due to slippery of the traction wire rope.
Startup protection control
If the elevator does not leave door zone with the designated time after it starts, it will stop the operation.
When the elevator enters into inspection operation, the car travels at inching running.
Up/down over-run and final limit protection
The device can effectively prevent from the elevator’s surging to the top or knocking the bottom when it is out of control. It results in more safe and reliable elevator travel.
Down over-speed protection device
When the elevator’s down speed is 1.2 times higher than the rated speed, this device will automatically cut off control mains; stop the motor running so as to stop elevator down at over-speed. If the elevator continues to down at over-speed, and the speed is 1.4 times higher than rated speed, safety tongs act to force the elevator stop in order to ensure the safety.
Upward over-speed protection device
When the elevator’s up speed is 1.2 times higher than rated speed, the device will automatically decelerate or brake the elevator.
In the door open and close period, infrared light that covers the whole door height is used to probe the door protection device of both the passengers and objects.
Emergency car lighting
Emergency car lighting automatically activated once power failure.
Five way intercom
Communication amid car, car top, elevator machine room, well pit and rescue duty room through walkie-talkie.
Fire emergency return
If you start key switch in main landing or monitor screen, all the callings will be cancelled. The elevator directly and immediately drives to the designated rescue landing and automatically opens the door.
Micro-touch button for car call and hall call
New type micro-touch button is used for operation panel command button in the car and landing calling button.
Floor and direction indicator inside car
The car shows the elevator floor location and current travel direction.
Floor and direction indicator in hall
The landing shows the elevator floor location and current travel direction.
Car ventilation, light automatic shut off
If there is no calling or command signal within the stipulated time, the car fan and lighting will be automatically closed in order to save the energy.
The elevator can be called to base landing (after finishing the service) through the key and automatically exist the service.
a,A new generation of energy saving ,smooth operation green freight elevator
c,strong design platform
d,Best choice for shopping malls ,supermarkets ,factories ,wholesale center,station,wharf or other warehouse bulidling to deliver the goods
Transport & Payment